LEXMARK ES460DN PRINTER DRIVER

The following will appear on the display: Remove the five screws C from the controller board. Email to friends Share on Facebook – opens in a new window or tab Share on Twitter – opens in a new window or tab Share on Pinterest – opens in a new window or tab Add to Watch list. Page of Go. Connect the cable to the controller board and loop it so that the closing and opening of the front access door does not cause bending.

Uploader: Shagore
Date Added: 28 August 2004
File Size: 66.36 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 31336
Price: Free* [*Free Regsitration Required]

Blæk og toner — LEXMARK

Media Never PicksW, -6EW Media never picks Action Paper feed pick tires tray 1 Open the left cover, and verify es460dh the solenoids and clutches are functioning Paper feed pick tires tray 2 when an attempt is made to feed the media.

Swing the front edge of the print cartridge guide to the right, and then toward the front of the printer.

Lexamrk Feed 1 Feeding Remove the three screws A. When replacing the strip for all trays: Install a Lexmark recommended memory Go to step Check the wear strips and replace if necessary. Remove the right side cover. IndexW, -6EW Index EP Defaults error log abbreviations clear log diagnostics mode acronyms display log diagnostics mode Print Log error messages buttons service error codes accessing service menus user attendance messages ESD-sensitive parts Lex,ark Roll, diagnostics mode compatibility During development, it could also have the wrong chip installed.

See Also  KNE100TX WINDOWS 7 DRIVER DOWNLOAD

Check the AC line voltage.

I also can be helpful here: Open the duplex jam door just far enough to pull out the ACM pick tires. Use a 1 Phillips screwdriver to remove the screw B holding the sensor. If the grid lines of the left flap align below the corresponding lines of the right side, then adjust the printhead counterclockwise.

Page 4W, -6EW Media occasionally mispicks or picks multiple sheets at once Page of Go. Align the new printhead relative to the location of the old printhead.

Disconnect the spring E from the cylinder. Electronics Page Page – Assembly 3: Page counts for each error The printed error log can be faxed to Lexmark or your next level of support for verification or diagnosis. See the wiring diagram at back of book.

Use the service error code, user status message, user error message, symptom table, service checks, and diagnostic aids in this chapter to determine the corrective action necessary to repair a malfunctioning printer. Printhead Assembly Mechanical AdjustmentW, -6EW Printhead assembly mechanical adjustment A printhead needs to be correctly positioned after it has been removed.

See Also  ML-4050N DRIVER

This report can also be printed from the Configuration Menu.

Lexmark ESDN Workgroup laser Printer – Low Page Count 4K | eBay

Excessive heat can cause media treeing problems, poor stacking, or curl. Make sure the cable is plugged in securely. Step Action and questions POR the device. Place the printer on its top with the rear facing you. PageW, -6EW Disconnect the front access door cable Band pull it through the opening to clear the side frame. If not, then lubricate only when parts are replaced or as needed, not on a scheduled basis. Remove the four screws B from the duplex.

The drip guard may need to be removed to access to the controller board. The line voltage to the printer must be within the following limits: Pull all the excess cable through the frame opening at the hinge and into the controller board area.